GSX1100G Build

[swirl]

Bought a GSX1100G a while ago to trike, a mate of mine was perusing facebook and spotted a q plated trike frame with all the back end sorted with handbrake etc so a cunning plan was hatched, I got up this morning at 4am and drove down to Stroud, was there about 7,15, loaded up on the road back up to Ellesmere Port for 10.30 good going, II started stripping the G and took some vital measurements, guess what the G motor wont go in the frame, some decisions to be made before the grinder comes out, pics to follow

[swirl]

Pictures added

[swirl]

think that top tube is gonna get sorted, may rake the front out a bit to, hmmmm tomorrow is a new day

[swirl]

frame mod maybe

[jinjachin]

That's what I'de do not to much work that frames going to save a lot of time and effort well done

[swirl]

frame mod, with addition of probably adding the bottom cradle and headstock from the G

[swirl]

Handbrake works, brakes are all plumbed in with master cylinder pedal switch the lot, rear lights arch etc all wired, best of all its on a q plate with sabtv vin

[swirl]

Well things have developed, without major surgery the 1100g motor wont go in, so what do ye do, yes sell it to ye mate and use ye other frame for ye G, the project continues

[Herby01]

What stops the G1100 going in? Is it that smaller tube below the top tube?

[swirl]

I wish mate, its to tall, to long and to wide, where the prop runs it goes straight through the swingarm pivot, sold it anyway, I've got a hardtail frame I'm going to use for the 1100g