Rewaco RF1 GT Rebuild.

[Flatcap]

You should be very proud of that Tiivp. Brilliant result and looks top dollar

[Baddon]

Not taking hours worked did you save much money against buy one

There is on problem that i cant get my head around.
When i first start engine (cold start) for a minute or so i cant touch throtthle if i run throtthle it will shoke and shuts down.
After a minut its ok and working fine.
If some rewaco owner reads this pleas let me know do you have same problem or you dont have it.
I think that it is somekind on sensor but witch one i to not know.
Because of that i try to learn about its custom ECU allsou, do get it diagnosted.

Sounds like an error with Automatic Choke. Mine starts no bother and idles rich/slightly fast for about 30-45 sec then slows to normal idle.
I can rev it though without cutting out, just choose not to if I can to let all get warmer before driving off.

[tiitvp]

Not taking hours worked did you save much money against buy one

There is on problem that i cant get my head around.
When i first start engine (cold start) for a minute or so i cant touch throtthle if i run throtthle it will shoke and shuts down.
After a minut its ok and working fine.
If some rewaco owner reads this pleas let me know do you have same problem or you dont have it.
I think that it is somekind on sensor but witch one i to not know.
Because of that i try to learn about its custom ECU allsou, do get it diagnosted.

Sounds like an error with Automatic Choke. Mine starts no bother and idles rich/slightly fast for about 30-45 sec then slows to normal idle.
I can rev it though without cutting out, just choose not to if I can to let all get warmer before driving off.

It seems todaly weird because it has only 5 sensors: T-map sensor, Crankshaft sensor, Throttle potentiometer and Lambda Sensor, water temp sensor.
T-map and Throttle potentiometer i have allready replayst. Only possible by my eyes is water temp sensor?
I try to check that and next is diagnostic ecu(What seems to be dangerouse if you do no know what are you doing..

[grumpygramps-2007]

lovely job.

[tiitvp]

Hi

Littlepit more information if someone needs it.
Radiator OLD Jeeps : Nissens 60986
Radiator vent : VA09-AP12/C-54S

As ventilator do not have code on it only companys name.
I searched from catalog and found one like needed.

[Deep Diver]

A job well done'

[Andy from Sandy]

When I first start engine (cold start) for a minute or so i cant touch throttle if i run throttle it will shake and shuts down.

Is the mixture set correctly?

Just seems symptomatic of rich and with choke closed it is just too rich to run.

[Jamie1441]

Hi

I don't suppose you remember what torque settings you used for the front fork assembly ?

I need the torque settings for all fork bolts
Aluminium block to stem top and bottom
Aluminium block to fork top and bottom
Front wheel nuts

[BoomF5]

Hi, You have done an awesome job, did you change the Steering head bearings?