Page 4 of 4
Re: Rewaco RF1 GT Rebuild.
Posted: Sun Jan 08, 2017 12:04 pm
by Flatcap
You should be very proud of that Tiivp. Brilliant result and looks top dollar
Re: Rewaco RF1 GT Rebuild.
Posted: Mon Jan 09, 2017 1:12 pm
by Baddon
tiitvp wrote:jinjachin wrote:Not taking hours worked did you save much money against buy one
There is on problem that i cant get my head around.
When i first start engine (cold start) for a minute or so i cant touch throtthle if i run throtthle it will shoke and shuts down.
After a minut its ok and working fine.
If some rewaco owner reads this pleas let me know do you have same problem or you dont have it.
I think that it is somekind on sensor but witch one i to not know.
Because of that i try to learn about its custom ECU allsou, do get it diagnosted.
Sounds like an error with Automatic Choke. Mine starts no bother and idles rich/slightly fast for about 30-45 sec then slows to normal idle.
I can rev it though without cutting out, just choose not to if I can to let all get warmer before driving off.
Re: Rewaco RF1 GT Rebuild.
Posted: Mon Jan 09, 2017 3:14 pm
by tiitvp
Baddon wrote:tiitvp wrote:jinjachin wrote:Not taking hours worked did you save much money against buy one
There is on problem that i cant get my head around.
When i first start engine (cold start) for a minute or so i cant touch throtthle if i run throtthle it will shoke and shuts down.
After a minut its ok and working fine.
If some rewaco owner reads this pleas let me know do you have same problem or you dont have it.
I think that it is somekind on sensor but witch one i to not know.
Because of that i try to learn about its custom ECU allsou, do get it diagnosted.
Sounds like an error with Automatic Choke. Mine starts no bother and idles rich/slightly fast for about 30-45 sec then slows to normal idle.
I can rev it though without cutting out, just choose not to if I can to let all get warmer before driving off.
It seems todaly weird because it has only 5 sensors: T-map sensor, Crankshaft sensor, Throttle potentiometer and Lambda Sensor, water temp sensor.
T-map and Throttle potentiometer i have allready replayst. Only possible by my eyes is water temp sensor?
I try to check that and next is diagnostic ecu(What seems to be dangerouse if you do no know what are you doing..
Re: Rewaco RF1 GT Rebuild.
Posted: Tue Jan 10, 2017 4:29 pm
by grumpygramps-2007
lovely job.
Re: Rewaco RF1 GT Rebuild.
Posted: Tue Feb 25, 2020 12:16 pm
by tiitvp
Hi
Littlepit more information if someone needs it.
Radiator OLD Jeeps : Nissens 60986
Radiator vent : VA09-AP12/C-54S
As ventilator do not have code on it only companys name.
I searched from catalog and found one like needed.
Re: Rewaco RF1 GT Rebuild.
Posted: Tue Feb 25, 2020 1:30 pm
by Deep Diver
A job well done'
Re: Rewaco RF1 GT Rebuild.
Posted: Tue Feb 25, 2020 2:16 pm
by Andy from Sandy
When I first start engine (cold start) for a minute or so i cant touch throttle if i run throttle it will shake and shuts down.
Is the mixture set correctly?
Just seems symptomatic of rich and with choke closed it is just too rich to run.
Re: Rewaco RF1 GT Rebuild.
Posted: Mon Jan 30, 2023 1:48 am
by Jamie1441
Hi
I don't suppose you remember what torque settings you used for the front fork assembly ?
I need the torque settings for all fork bolts
Aluminium block to stem top and bottom
Aluminium block to fork top and bottom
Front wheel nuts
Re: Rewaco RF1 GT Rebuild.
Posted: Sun Jun 11, 2023 9:50 pm
by BoomF5
Hi, You have done an awesome job, did you change the Steering head bearings?