so bit more progress, axle shortened and rear blocks mounted on, the inside has been sleeved with 3mm tube the full width of each side so all is good there. onto my half shafts now hoping to finish machining them down this weekend.
axle blocks welded to the frame, Jesus I didn't realize how much power the big welder had, took me a while to get the setting right was running it around half power and 1/3rd wire speed seemed to go pretty good loads of penetration. I added some supporting to where the blocks sat half way across the tube so loads of meat in that back end! so next job finish the half shafts, sort the drive shaft then i can get cracking on the front end. some pics -
43.jpg
39.jpg
38.jpg
You do not have the required permissions to view the files attached to this post.