indicators from china

[old git]

Just fitted Chinese indicators which flash double time the bulbs are 10wat as apposed to twenty has any one came across this problem or any knowledge how to fix this problem.

[Davey the punk]

If there LED ones you will probably need a relay I read about it on a bike forum a couple of years ago hope this helps

[1130cc]

Yep, LED ones will either have a resistor inline, or you can buy a LED specific flasher relay.

[old git]

Not led but ball bulbs and as i say 10wat need to find 21wat off set pins but hitting a brick wall.

[Kawazuki]

If they are those 'mini' type indicators you will be out of luck! And a 21w bulb in there melts the plastic - ask me how I know! ! !
Easiest solution is add a 20 ohm 10w resistor into each ground line to each indicator but that may make them a bit dull. Best solution
use LED types and change the flasher relay or proper 21w indicators!

[Mal]

When i fitted extra LED inds to my old Waco because it was a mix of bulbs and LED it all went haywire. i found a 4 pin led relay from landrover with adjustable resistance. it had a little knob on the back and i found i could tune it up and down until everything worked.

[rocketray]

This is a LR part & comes as a standard fit on Defenders. As Mal says merely adjust the resistance to suit what lamps/LESs you are using. easy !!!
UPC 5056342710768

[old git]

just ordered resistors will let you know how i get on

[old git]

fitted these RGR0001 resistors which has made no difference .

[Mal]

Have you wired them in Parallel or Series. I think they need to be wired in series so they load the system.